Re: Pocket programmer users...

["Jim Wilson" <Wilson.James4@worldnet.att.net>]

I had the same problem with my pocket programmer. I found that when I left
the EPROMS in the eraser for 30 min. everything was OK. Every now and then I
will still have a bad EPROM I cannot erase so I figure it must be a bad
chip.

                                  Jim

-----Original Message-----
From: David Tuschhoff <davidlt@i-55.com>
To: GM-ECM List <gmecm@diy-efi.org>
Date: Tuesday, October 10, 2000 8:31 PM
Subject: Pocket programmer users...


I seem to be having trouble with mine.  I'll run a blank check on an
eprom(27c256), it checks blank and then when I try to program the chip, it
comes up error.  Some work and some don't.  Also, after I erased a chip, and
do a blank check it still finds data....even after it sat in the eraser for
24 min.  Could be a couple bad chips I guess.  Any advice!  TIA!!

Later,

David Tuschhoff - (davidlt@i-55.com) (http://www.i-55.com/~davidlt)
1991 RS/Z28 Camaro - A Superrammed, TPIS, AFR, Ross, Scat,
Crane, Comp induced 355 V8!

For all your performance needs call me toll free at (877)516-RACE
(davet@thunderracing.com) (http://www.thunderracing.com)


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org



----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org