Re: howell730 bin file

[Squash <realsquash@yahoo.com>]

The howell730 runs quite rich at idle on a port-injection system.  That's prolly why the BLM goes
to 108 and then resets.

Squash

--- chetwagner@uswest.net wrote:
> A while back I was using the howell730 bin file for a project I was 
> doing.  This code is an 8D mask, like the ANHT and AUJP bin's, but 
> runs completely different than the others, especially at idle.  When 
> idling, the integrator numbers go down about 1 every second and 
> then when they reach the lower limit, they jump up to 128 and start 
> to count down again.  When they reset, the fuel seems to shut off at 
> the injectors but not enough to stop the engine.  I find this strange.  
> If I remember right, someone noticed some extra code at the end of 
> the program.  I wonder if the extra code has anything to do with the 
> above.  
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> 


=====
Trains, Trucks, and EFI at http://www.trailrunners4x4.org/users/realsquash

__________________________________________________
Do You Yahoo!?
Yahoo! Messenger - Talk while you surf!  It's FREE.
http://im.yahoo.com/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org