Re: 7747 spark control questions.

[Squash <realsquash@yahoo.com>]

You got it!  I was confusing the two terms. :)  I had it figured out, and I guess I was right and
shouldn't have thought so much about it.  

If it still matters, AUJP with table changes, and promedit and winbin, and my own ECU file.  It
shows the raw values, doesn't have provisions for adding another location...

Squash

--- Kevin R <KEReyn@gte.net> wrote:
> Squash,
> 
> What bin are you using and what are you reading/editing(TC,Winbin,hex
> editor?) it with.
> I think the problem comes from the bias settings being confused with the
> base timing setting.
> 
> Kevin R
> 
> > Wait, my brain just went numb.  Too many numbers.  Table says 20, Bias
> says 4 and dist is set to
> > 4, total timing measured with a light is 16.
> >
> > Squash
> 
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> 


=====
Trains, Trucks, and EFI at http://www.trailrunners4x4.org/users/realsquash

__________________________________________________
Do You Yahoo!?
Yahoo! Messenger - Talk while you surf!  It's FREE.
http://im.yahoo.com/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org