Re: Application for ASCP bin?

[Roger Heflin <rah@horizon.hit.net>]

On Sat, 21 Oct 2000, Bruce Plecan wrote:

> I'm using a Snap-On book, and half reading between the lines, but it looks
> like:
> 
> the BZDLis superceded to a 16216379 which is a BNXF that was isued to cure
> Chuggle at 1,500-2,000 rpm, or 55-60MPH
> The whole ASxx series show no updates
> But, this book is a few years old now.
> 
> Have you tired test driving it?
> Bruce

The car is *way* too modified to try running anything even close to
stock.    I ran a 12.18@109 with a 1.668 60ft earlier today, after I
get quite a bit more fuel in it, and take the header dumps off (it ran
that through a 3" single exhaust), and should be well into the 11's on
the motor.     Someone else sent me what is the newest chip in the
line, so it will check it and see what it has that is different from
the one I am running.

I have run  the chip after reprogramming it, I was also worried about
it having the correct knock module setup in it for my vehicle.

				Thanks,
				Roger

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org