Re: Need small IAC

[Bob Valentine <bob@tecmark.com>]

The smallest *GM* IAC I've seen are the bolt-in types found on later
4-cylinder TB's, some Vortec TB's, and on at least one BBC TB.    The
outside diameter is about the same as the standard type, but two small
screws are much easier to fit than a 11/16" thread.  

Ever consider using a aftermarket external IAC housing?  I think BDS makes
one, used on their stack EFI conversions.    

-> Bob
-> bob@tecmark.com

At 01:33 PM 10/27/2000 -0600, you wrote:
>No picture. It's in the design phase at this time. I'll design it to what I
>can get for an IAC. The smaller the better.
>
>Eric
>
>Swayze wrote:
>> 
>> got a pic of the TB?
>> Swayze
>> mswayze@truswood.com
>> kswayze@bellsouth.net
>> <8-{b>
>> ----- Original Message -----
>> From: "Eric Norgard" <eric@aztek-eng.com>
>> To: "gmecm" <gmecm@diy-efi.org>
>> Sent: Friday, October 27, 2000 1:48 PM
>> Subject: Need small IAC
>> 
>> > I'm currently in the process of building a throttle body for my PFI
system
>> and
>> > I need a IAC. I'm looking for an IAC that would be small and mount on
>> > to the throttle body. Any recommendations on a vehicle that would work
and
>> or
>> > a source for them. If it makes any diffence, I'm running the 730 ECU.
>> >
>> > Thanks
>> > Eric
>> >
>> > --
>> >
>> > Eric Norgard
>> > Software Engineer           Voice: 303-415-6146 (Direct)
>> > Aztek Engineering Inc.             303-786-9100 (Receptionist)
>> > 2477, 55th St., Suite 202   Fax  : 303-786-9190
>> > Boulder, CO 80301-2835      Email: Eric.Norgard@aztek-eng.com
>> >
--------------------------------------------------------------------------
>> --
>> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>> > in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>> >
>> >
>> 
>>
----------------------------------------------------------------------------
>> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>-- 
>
>Eric Norgard
>Software Engineer           Voice: 303-415-6146 (Direct)
>Aztek Engineering Inc.             303-786-9100 (Receptionist)
>2477, 55th St., Suite 202   Fax  : 303-786-9190
>Boulder, CO 80301-2835      Email: Eric.Norgard@aztek-eng.com
>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org