Re: 730 ECM Swap

["Dan Townsend" <xybertron@cox-internet.com>]

FWIW - I have ordered a couple (3) ecm headers along with 200 of the
connector pins and 1 of each of the 3 connectors.  Total cost of $42.

I will be using 2 headers and have promised the third to Mark Romans.

As soon as I get them.  Hopefully the end of the week I will plug up
everything and see if it all works.  Then the easiest thing will be for me
to send each of the interested individuals the part numbers and then ya'll
get into a group of three and order them.  This will get you the $25 minimum
purchase covered.  I procrastinate stuff too much to get them all shipped
out in a timely manner or else I would.

Sound like a good plan?  BTW - They don't do credit cards so I did COD on my
order.

Dan

----- Original Message -----
From: <WEG1192@aol.com>
To: <gmecm@diy-efi.org>
Sent: Tuesday, November 07, 2000 3:02 AM
Subject: Re: 730 ECM Swap


> Here is the list of names who wanted a '165 to '730 conversion harness.
> Whoever wants to take over this project, be my guest.  JW
>
> romans@starstream.net (Romans)
> xybertron@cox-internet.com (Dan Townsend)
> toddburkard@pcmc.com (Todd Burkard)
> jwn@sgi.net (JN)
> smarteney@xlvision.com (Marteney, Steven J.)
> gellett@earthlink.net (Gabe)
> rawardsr@hotmail.com (Robert Ward)
> thartman@fastlane.net (Terry)

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org