Re: head gaskets

[John_Calabrese@ENGELHARD.COM]

I would have the surfaces not only checked for straightness, but
refinished, maybe even the block as well,  The surface should have a max
.005" distortion to it, and a proper finish (120 rms?)  for good head
gasket sealing.  Putting it back together and just cleaning surfaces really
isn't that god of an idea

Just my.02



John L. Calabrese
Research Engineer
Environmental Technologies Group
Engelhard Corporation

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org