[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: DIS Ditty



isn't the 70 to 60 figure BTDC?

Swayze
mswayze@truswood.com
kswayze@bellsouth.net

----- Original Message -----
From: <JTesta1966@aol.com>
To: <gmecm@diy-efi.org>
Sent: Monday, November 13, 2000 4:35 PM
Subject: Re: DIS Ditty


> In a message dated 11/13/00 3:39:22 PM Eastern Standard Time,
> nacelp@bright.net writes:
>
> << If some one sees the error in changing the reference angle from 70 to
60,
>  and then adding 10d to the base spark table please let me know. >>
>
> Why would you do that Bruce? So it starts easy but you can run lots is
> initial advance?
>
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Jim  (FA) Testa                                             TType86 on
> #BuickGN
> ASE Master Technician
buick.fiendish.net:6667
> L1 Advanced Engine Performance                    NJ Lic MV Inspector
> jtesta1966@aol.com                           NJ Lic Emission Repair Tech
> http://members.aol.com/jtesta1966/buick.htm
> Associate Sponsor, Buicks at Bristol (RCA/JTP)
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org