It's a bigger problem with the OHC heads...cam bore distortion gets
pretty bad with a re-torque after machining beyond the spec. We
just chuck 'em...it's not worth a comeback.
Lyndon.
-----Original Message-----
From: Bruce Plecan <nacelp@bright.net>
To: gmecm@diy-efi.org <gmecm@diy-efi.org>
Date: November 13, 2000 9:57 PM
Subject: Re: head gaskets
>This sound primitive.
>I have a 2" wide 24" long file.
>If a head fails the flatness with a straight edge I use the file.
>Sometimes is just almost accidential they fail the straight edge test.
>Other then the OHC stuff I've fudged things without dire results, on my own
>stuff.
>bruce
>
>
>
>----- Original Message -----
>From: "Programmer" <nwester@eidnet.org>
>To: <gmecm@diy-efi.org>
>Sent: Sunday, November 12, 2000 5:44 PM
>Subject: Re: head gaskets
>
>> .005" ?? I'd only settle for .000"
>> Nowdays, .006 can be the
>> warp discard of the head...
>>
>> Lyndon.
>> -----Original Message-----
>> From: John_Calabrese@ENGELHARD.COM <John_Calabrese@ENGELHARD.COM>
>> To: gmecm@diy-efi.org <gmecm@diy-efi.org>
>> Date: November 10, 2000 7:47 AM
>> Subject: Re: head gaskets
>>
>>
>> >I would have the surfaces not only checked for straightness, but
>> >refinished, maybe even the block as well, The surface should have a max
>> >.005" distortion to it, and a proper finish (120 rms?) for good head
>> >gasket sealing. Putting it back together and just cleaning surfaces
>really
>> >isn't that god of an idea
>> >
>> >Just my.02
>> >
>> >
>> >
>> >John L. Calabrese
>> >Research Engineer
>> >Environmental Technologies Group
>> >Engelhard Corporation
>> >
>>
>>--------------------------------------------------------------------------
-
>> -
>> >To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>> >in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
>> >
>>
>> -------------------------------------------------------------------------
-
>--
>> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>>
>>
>
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org