[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

PROM Size on a 165



Newbie working on a 165 ECM. I have many 256 PROM's but no 128's. I'd like to put the 256's to work. The schematic's I have seen on ECMGUY's site, show what looks like PROM pin 27 wired to A14 of the ECM bus. (CS and OE are also reversed) This does not make sense. Pin 27 of the original 128 PROM is /pgm pin, which should be tied high in the ECM.

I'm guessing the schematic was made from a later version ECM that takes 256 PROM's. (Hense the A14 connection.)

Does the MEMCAL not interface w/ A14 on the ECM board? i.e. Does the MEMCAL tie PROM pin 27 high? Can someone confirm that PROM pin 27 on a 165 ECM is held high all the time? Will using a 256 part for a 128 ECM cause error conditions for certain BIN editors? i.e. Do the editors check this?

I apologies if this has been discussed before, I have not yet found the archive seach.

ML

_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.

Share information about yourself, create your own public profile at http://profiles.msn.com.

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org