Re: Schematic for 1227730 ECM

[Peter Gargano <peter@techedge.com.au>]

Ludis Langens wrote:
> 
> donburns@macconnect.com wrote:

> > In the O2 sensor input circuit I see a 100 ohm
> > resistor shunted to ground with a capacitor. 
> 
> The capacitor is small, probably something like 0.001 uF.  All the caps
> without values in the schematic are small surface mount devices.

A Delco schematic I've seen for the 1277808 has a 0.01 uF cap to ground on
each of the O2 amplifier inputs. This is in addition to the 0.001 uF caps
to ground right at the J1 connector. I'd be surprised if the 1227730 doesn't
use exactly the same values.

Peter
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org