Re: Distributorless ignition (I'm new around here)

[Speartech <speartec@iquest.net>]

The Northstar!!

	John

>Date: Tue, 28 Nov 2000 15:22:50 -0500
>From: "Bruce Plecan" <nacelp@bright.net>
>Subject: Re: Distributorless ignition (I'm new around here)
>
>
>Which caddy used an ignition module like a buick v-6?
>Bruce
>
>
>
>
>> What about the caddys?
>> >>> nacelp@bright.net 11/28 1:08 PM >>>
>> The ZR1 vettes, are the only ones I know of
>> Bruce
>
>
>> > Do any of the Yank GM cars run a 8 Cyl DIS spark system that we could
>> adapt
>> > the ignition module off like the Buick V6
>> > -----Original Message-----
>> > From: Bruce Plecan <nacelp@bright.net>
>> > To: diy_efi@diy-efi.org <diy_efi@diy-efi.org>
>> > Date: Thursday, November 23, 2000 4:46 PM
>> > Subject: Re: Distributorless ignition (I'm new around here)
>> >
>> >
>> > >
>> > >Electromotive sells all the bits to do that, and even  a.
>> > >ZR-1 are a parts source but rare.
>> > >Alternatives use two electromotive sensors and tone rings, inside the
>oem
>> > >dissy
>> > >Some reading at the 332 site.
>> > >MSD supposedly has a v-8 dissy for SEFI so it has a synch signal, if I
>> > >recall right.
>> > >Bruce
>> > >
>> > >>      I am intrested in making a distributorless ignition for my early
>> V8
>> > >> engine...My electronics training is limited to a junior college
>> > >"Introduction
>> > >> to electronics" course and a semester of "Electronic math".  I have
>> read
>> > >> Drury's DDIS article...but even that was a little much for me, as I
>> > didn't
>> > >> understand alot of the lingo.

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org