Re: Jargon, Terminology, Terms ....

[rr <RRauscher@nni.com>]

I think thats a yep, yep and yep. See incoming for ANHT.bin, it's
an $8D mask id.

BobR.

Marteney, Steven J. wrote:

> For further clarification, the mask ID is at location $8008 as seen by the
> microcontroller( through its memory map, correct?  In other words, it is at
> $0008 if one were to just straight read the EPROM?  The reason I ask is I
> know in a $6E prom it is at $0008 when viewing with a hex editor.  I haven't
> seen an $8D chip yet. :-(
>
> Steve
>
> -----Original Message-----
> From: timsiford@hushmail.com [mailto:timsiford@hushmail.com]
> Sent: Tuesday, December 05, 2000 1:17 PM
> To: gmecm@diy-efi.org
> Subject: Re: Jargon, Terminology, Terms ....
>
> Shannen, Bruce ...
>
> Thanks.
>
> As a specific quick example ...
> Scan ID = Prom ID = Positions $8000-$8001for '86-'92 TPI F Bodies
> BCC = AUJP, ANJF, etc = 4 letter designation on Silver GM sticker
> Mask = 8D, 6E, 32, etc = Position $8008 for '86-'92 TPI F bodies.
>
> Thanks again ... truly appreciate it.
>
> Tim

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org