Re: converting a GM non computer hei distributor to a computer hei

[Bob Valentine <bob@tecmark.com>]

I'll bet the rotor will move just enough to cause a headache if you just
yank the weights and leave "strong" springs in as shown below.  Either weld
it or lock it down with a small nut and bolt.   

-> Bob Valentine
-> bob@tecmark.com

At 01:59 PM 12/11/2000 EST, you wrote:
>Diane,
>
>Go to http://members.aol.com/weg1192/sparktuning.html  
>
>If this doesn't answer all your questions, email me off list.
>
>JW



>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org