Re: strange check engine light

[Bob Valentine <bob@tecmark.com>]

If you were using the $AA experimental mask ID, then the checksum is
ignored and a bad burn would go un-noticed.    This was mentioned a few
weeks ago (forgot who), I've switched back to using the proper mask ID and
checksum... never had a problem before (that I noticed) but good insurance.

-> Bob Valentine
-> bob@tecmark.com

At 12:43 AM 12/15/2000 EST, you wrote:
>I took care of the problem but not necessarily "solved" the problem. I 
>reprogrammed a known good MEMCAL with the same bin and it did the same
thing. 
>So I went back and re-edited the bin and the problem went away. Not sure
what 
>was the cause, but symptom is gone.  JW
>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org