Re: Olds 350 donor

[Shannen Durphey <Shannen@grolen.com>]

This is true.  But areas with snowy winters had problems with ecm
connectors and ecm failures with the under seat7747's.  Especially in
states which use salt on the roads.  Astros work well with the ecm
mounted inside the RH kick panel.
Shannen

Bob Valentine wrote:
> 
> That's how it's done on a van.   Harness comes down behind dist, snakes
> over to under the driver's seat.   Has a nice pass-thru grommet where it
> goes thru the floor, and a metal shield to guard the harness where it goes
> under the frame rail.
> 
> On 2nd thought using a '727 wasn't such a good idea.  I've burned 80 chips
> or so, and a few of those were only in the car for less than a couple of
> miles...
> 
> -> Bob Valentine
> -> bob@tecmark.com
> 
> At 03:17 PM 12/17/2000 -0500, you wrote:
> >What under the passenger seat?.
> >How about along frame rail, and then thru floor pan near seat.  Means long
> >runs but, is an answer
> >Or gather wiring by dissy, then down tranny tunnel and enter by passenger
> >seat tracks (again floor pan area).
> >Bruce
> >
> >
> >
> >
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org