[Diy_efi] Measuring Pulse Width/Duty Cycle of an Injector
niche at iinet.net.au
Tue May 24 00:14:28 CDT 2005
At 01:52 AM 24/05/05, you wrote:
>Everybody seems to be making this complicated, just connect the diode of an optical isolator with a current limiting resistor across the injector (between the 12v supply and the driver for a GM type) and use the signal developed by the transistor, should be nice and clean low when injector on and high when injector off.
Exactly and use a bipolar opto so polarity isnt a problem etc
>Robert W. Hughes (Bob)
>29:40.237N, 95:28.726W or perhaps 30:55.265N, 95:20.590W
>Houston, Texas "The city with too much Oxygen"
>rwhughe at oplink.net
>Diy_efi mailing list
>Diy_efi at diy-efi.org
Perth, Western Australia
VL Commodore Fuse Rail that wont warp or melt !
More information about the Diy_efi