[Diy_efi] Reflow - was Here's a little micro to build on...
b.shaw at comcast.net
Wed Sep 5 06:50:31 CDT 2007
You mean like this?
It actually works very well. :-)
Gregg Eshelman wrote:
> --- Torbjörn Forsman <torbjorn.forsman at gengas.nu>
>> But a 272-pin BGA is not so easy for a DIY project,
>> using a such package
>> means that the PCBs have to be assembled and
>> soldered on a proper
>> production line. I am somewhat reluctant to using
>> BGAs for automotive,
>> military and other demanding applications as the
>> package and solder
>> balls are entirely stiff. There is nothing like the
>> soft bent pins of a
>> QFP or PLCC that can relieve thermal stresses etc.
> There are sockets for BGA chips but I expect they're
> plenty expensive, and probably are themselves surface
> Then there's Intel's Pentium 4 line that use the
> LGA775 socket. Leadless Grid Array. It has 775 little
> springy spikes poking up to contact pads on the bottom
> of the CPU. The chip's held down by a steel clamp ring
> and locking lever. (Remember the LCC style 80286?
> Everything old is new again!)
> I've heard of people doing SMT soldering in a toaster
> oven- suitably upgraded with a pyrometer controlling a
> switch in the line cord. Set the pyrometer and turn
> the oven up to max. ;) That takes the oven's
> thermostat out of the control loop. Turn the board
> upside down for an SMT desoldering unit, just be sure
> to supply a tray to catch the parts!
> Choose the right car based on your needs. Check out Yahoo! Autos new Car Finder tool.
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> Subscribe: http://lists.diy-efi.org/mailman/listinfo/diy_efi
> Main WWW page: http://www.diy-efi.org/diy_efi
More information about the Diy_efi