[Diy_efi] [slightly ot] Differential Pressure Measurement gauge, alternatives ?
spyro at f2s.com
Fri Sep 7 04:28:09 CDT 2007
On Fri, 2007-09-07 at 00:19 -0700, Gregg Eshelman wrote:
> You'll definately want an airflow source for the hot
> side of the peltier that comes from outside the engine
> compartment and exhausts to outside it too.
> You'll also want a LARGE cooler block with a very long
> or otherwise high area path for the water to flow
> through so it can shed as much heat as possible.
I was going to bolt something like a PC watercooling block to it to give
a nice high area passage for the water.
I also discovered that the solenoid will probably get rather warm. Im
going to have to make sure this doesnt heat the water! spec says
solenoid at 100% duty will hit 90 degrees! I dont think this will carry
to the water too much though looking at the design. We shall see.
More information about the Diy_efi