RE: 89 MAF Volt to freq conversion

[Mike Rolica <mrolica@meridian-mag.com>]

I'm working on the apyu 89 165 f body.  Have not found that option like in
the bua.  Also cannot find the damned fuel table..PW vs LD!......
Mike Rolica
Meridian Magnesium Products
Strathroy, Ont 
Ext. 260


	-----Original Message-----
	From:	DC Smith [SMTP:morepoweral@tetranet.net]
	Sent:	Wednesday, January 05, 2000 10:43 AM
	To:	gmecm@efi332.eng.ohio-state.edu
	Subject:	Re: 89 MAF Volt to freq conversion

	Hey, Tom! It's been over 2 days and no reply on this one? Gee, if it
	were only true for the 7148 Buick GN code. It sure would puit a
cramp in
	the MAF translator sales, since the GN MAF went disc.. :) MAN! I
need to
	read more of those web pages! <grin> 

	 Anybody know anything about this? Pulleeze? ;)

	 BTW, happy new year friends!

	Thomas Matthews wrote:
	> 
	> In the ECMguy's hack of the 86 '165 bin, he has a flag for MAF
type, voltage
	> or frequency... Does anyone know if this is present in the 89 ARAP
($6E)
	> calibration, and if it is there, where it is?
	> Is it as simple as flipping the volt to frequency flag, and
recalibrating
	> the calibration to use a newer, higher flowing GM MAF, such as a
LT1 sensor?
	> He also has 6 tables that define the range of a frequency MAF, but
in the
	> showing of the tables he has voltages- would these be the ones to
adjust?
	> Is some other part of the program performing a conversion from
voltage to
	> frequency that I have missed?
	> Also, I've seen numerous references to VATS- I thought it did not
come along
	> until '88.
	> I remember that some were heading this way a few months ago, but
haven't
	> seen anything recently...
	> Thanks
	> Tom

	-- 
	
***********************************************************************
	Dan Smith      84 Regal   11.841@115.09     GSCA# 1459
	St.Charles, Missouri 
	mailto:morepoweral@tetranet.net               
	http://www.tetranet.net/users/morepoweral
	
***********************************************************************