Re: Plug reading

[David Cooley <n5xmt@bellsouth.net>]

At 10:32 AM 3/7/2000, you wrote:
> Hmmm....Is the MAF contaminated ? It'll make this thing
> run on the lean side. Any pinging ? Are you monitoring
> with a scan tool during the runs ? Using the dual plats ??

Cleaned the MAF about 2 hours before the run.  No pinging, Using Alex 
Pepers OBD-II scantool.
O2 volts seems to stay between 880mV and 950mV at WOT.
Using stock dual plat plugs, factory recommended gap.


One other thing...
Before the K&N, Exhaust, and air box mods, the Long term fuel trim at 
cruise would average -10%.  Now it averages -2%... Appears it's flowing 
more air so it has richened it up a little.  Also, Max airflow at ~4600 RPM 
is 25.025 pounds/minute or 189.35 g/s

===========================================================
David Cooley N5XMT Internet: N5XMT@bellsouth.net
Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
We are Borg... Prepare to be assimilated!
===========================================================

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org