Re: First GN chip

["nacelp" <nacelp@bright.net>]

I was going to go probably with a plenum location.
Also, try the Tranny temp sensor, that I posted about (fast response time).
Just have to have a WB O2 thou (well this is a good excuse to buy one).....
Grumpy


> >Got to admit a clever way of being able to record boost,  during a run,
but,
> >I'd rather work on getting the temp corerctions worked out so that the
> >engine is happiest.   If ther isn't enough  retarding per temp, then that
> >could explain alot of head gasket failures...  I got to look closer at
this.
> The bad thing about the GN MAT sensor is it's right after the air filter,
> but before the turbo... Probably why they didn't really do much with it.
> If it was in the intercooler to TB pipe, where it actually measured the
> temp of the air flowing into the manifold, then a decent set of
corrections
> could be written.
>David Cooley N5XMT Internet: N5XMT@bellsouth.net


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org