RE: VE#1 + VE#2 can I zero ve#2 until 3200 rpm??

[Carl Summers <InTech@writeme.com>]

Hi Pablo,
    I have never tried zeroing the adder table below 3200....but have
reduced it radically with no downfalls......I would think you would have to
have a really radical cam allowing almost no vacuum below 3200 to take
advantage of this...but keep us posted of what you find and I for one would
be willing to help in any way I can...
-Carl Summers



-----Original Message-----
From: owner-gmecm@diy-efi.org [mailto:owner-gmecm@diy-efi.org]On Behalf
Of olbap
Sent: Tuesday, April 18, 2000 7:35 PM
To: gmecm@diy-efi.org
Subject: VE#1 + VE#2 can I zero ve#2 until 3200 rpm??


Hi everyone,
  Would there be any adverse effects if i just zero'ed VE#2 up till 3200 rpm
since they both add anyways? Then fill in from 3200 on up to get the upper
rpm stuff right. Just seems to me like it would eliminate some hassle
balancing two tables for no reason in the primary driving zone.
by the way im using the 8746 ecm.. .basically the same as the 7747
So would I be ok?

I appreciate any help
Thanks,

Pablo

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org