Re: Injector driver

[KasaRyan@aol.com]

Ok - Since I have 2 TBI injectors in series on each TBI driver, and I suspect 
that they do not work optimally because of it, what are my options at this 
point in the game.  I have a 400ish HP 383 and have 1.0-1.2mS pulse width at 
750 idle and 4.8-5.0 mS at 6000 under load.  The driver will not fire 2 
injectors in parallel at all off each channel.  Here are some ideas I had:

1-status quo - it works but atomization could be better.
2-buy or build someone elses pre thought out driver board or product
3-wire the driver to one set of injectors, use that signal to drive a simple 
transistor switch to operate the second injectors.
4-wire the driver into the Q switch, have the siwch run all the injectors.
5-wire driver to injectors, hook car stereo amplifier to injector wire, hook 
output to second inectors, use o-scope to set amp gain so amplitudes kinda 
match.
6-I'm open to suggestions and would like to know if the prom really needs to 
be removed from the 93&up carrier thingie to be read/programmed.  seems like 
you could just connect the reader wires to the IDE-like connector on the 
bottom of it.

Thanks for listening to my electroyappin!
Ryan Hampl - a K-State Grad!    kasaryan@aol.com
139 Hoover Ct.                  Controls Engineer (tubes rule!)  
Salina, KS  67401               97 B12 / 86 V65 / 93chevy truck EFI 383
phone  (785) 825 5831           I'M ALWAYS FIRST TO THE GROCERY STORE!
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org