[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: turbo seca - maf>turbo
Hmm, wonder if there was more then one strategy?.
I thought the wire was held at a specific temp, and the current to maintain
that was used to figure the aair mass
Grumpy
> GM sensors I have seen use the hotwire *AND* a temp sensor in the MAF
>flow so it can see the actual air temp and the hot wire is maintained 75
Deg C
> (I think that's right... from the Buick GN sensors) above the incoming
air
> temp.
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org