Re: 1998 O2 sensor

["alexpeper" <alexpeper@email.msn.com>]

That could be www.obdii.com  the schedules do vary between
manufacturers.  Chiltons and Motors manuals 96+ have
good(near equivalent to factory) description of conditions
needed to set code.  For regualatory description check EPA
or ARB web sites.  SAE J1850 is comunication protocol.  SAE
J1979 Mode 05 contains 02 sensor monitoring test results.
Alex C. Peper
http://www.obd-2.com

----- Original Message -----
From: Garfield Willis <garwillis@msn.com>
To: <gmecm@diy-efi.org>
Sent: Thursday, June 29, 2000 2:28 PM
Subject: Re: 1998 O2 sensor


> On Thu, 29 Jun 2000 09:39:57 -0400, David Cooley
<n5xmt@bellsouth.net>
> wrote:
>
> >... To force a cat test, you need
> >to accelerate moderately from 30 to 60 then coast with
the foot off the
> >brake and off the gas, no downshifting, until you reach
30MPH.
> >http://www.obd2.com/ lists the different drive cycle
tests.
>
> Could you point me more closely to the right spot on the
above cite
> where this is found? I rooted about there for a good while
and couldn't
> find the test definitions. Truly, I am a putz, I know. :)
>
> TIA,
> Gar
>
>
> ----------------------------------------------------------
------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm"
(without the quotes)
> in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
>



----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org