Re: 1227747 question

[David Cooley <n5xmt@triad.rr.com>]

At 12:41 PM 8/7/2000, you wrote:
> I'm helping a friend with a problem on a 1227747 in a 88 C-10.  Long story
> short, the ECM goes into closed loop within 5-10 seconds at any temp - cold
> or hot.  I don't have much experience with the '747 but I believe there are
> min run times in the prom before closed loop is allowed.  Is there something
> that can overide this?  What are the times in the '747 code?  I know on the
> '165 I'm use to messing with the times usually run around 60 seconds on the
> cold side to about 300 seconds on the hot side.  Is this comparable?


It should be not only minimum run time, but also a minimum coolant temp for 
CL operation as well.


===========================================================
David Cooley N5XMT Internet: N5XMT@triad.rr.com
Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
I am Pentium of Borg... Division is Futile!
===========================================================

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org