Re: Plug Reading

["Dominic Sorresso" <surrexi2@home.com>]

Bruce,

I was referring to the fact that it seems there are 2 Xfire manifolds. One
with balancer holes between opposing intake tracks and one without. The one
without being the earlier version, apparently.

Dominic
----- Original Message -----
From: "Bruce Plecan" <nacelp@bright.net>
To: <gmecm@diy-efi.org>
Sent: Wednesday, August 16, 2000 4:24 PM
Subject: Re: Plug Reading


> Balancer issue?.
> No hole torque
> With hole higher rpm breathing, at expense of off idle (well low rpm)
grunt.
> Had ported twoo manifolds  and was doing back to back testing to make sure
> my porting was even beftween the two.  I hadn't done a before test.
> HAhahahaha,  boy did I fell stupud on that test drive.
> Bruce
>
>
> > Sounds like the balancer/non balancer hole issue with the Xfire
manifold.
> >
> > Dominic
> > ----- Original Message -----
> > From: "Ernst denBroeder" <edenbroe@cisco.com>
> > To: <gmecm@diy-efi.org>
> > Sent: Wednesday, August 16, 2000 9:34 AM
> > Subject: Re: Plug Reading
> >
> >
> > >
> > > >
> > > > > Ohh the intake works so much better...thank you thank you...
> > > >
> > > >Welcome.
> > >
> > > Mike / Bruce,
> > >
> > > This mod, was that the suggestion of drilling some holes in the TPI
base
> > to
> > > sorta siamese the runners?
> > >
> > > Just curious...
> > >
> > > Thanks,
> > > Ernst
> > >
> > >
> >
>
> --------------------------------------------------------------------------
> > --
> > > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
> > > in the body of a message (not the subject) to
> majordomo@lists.diy-efi.org
> > >
> >
>
> --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org