Re: Ford injectors

[timsiford@hushmail.com]

24# SVO injectors are Blue top
30# SVO injectors are Red top

Tim

At Thu, 17 Aug 2000 04:27:26 -0500, "Dan Townsend" <xybertron@cox-internet.com> 
wrote:

>
>The dark blue 30# svo injectors that I had did have the grooves and 
>I got
>them about a year ago.  I have ran the injectors without the retention 
>clips
>with no problems.  Just be careful when you put the rail back together 
>not
>to cut an o-ring like I did.  The o-rings I am talking about are part 
>of the
>rail assembly not the ones on the injectors.
>
>Also the 30# will work with a stock chip on a stock engine but don't 
>go WOT
>:-)
>
>From: "Dan Plaskett" <dynastydan@worldnet.att.net>
>Subject: Re: Ford injectors
>
>
>> Ditto on 30lb injectors on my 406 TPI 86 vette.  These did not have
>grooves
>> cut for the retention clips.  When first installed I had to work with 
>them
>> because when the fuel pump kicked on I had fuel everywhere.  Eventually
>got
>> them adjusted so I don't have fuel leaks but I've always been a little
>> concerned that I might be pulling some vacuum from the bottom injector
>seal
>>
>> Dan Plaskett
>>
>> ----- Original Message -----
>> From: "Craig Marcho" <marcho@flash.net>
>> To: <gmecm@diy-efi.org>
>> Sent: Wednesday, August 16, 2000 7:26 PM
>> Subject: RE: Ford injectors
>>
>>
>> > I've put the 24lb Ford injectors on my '85 TPI 'Vette and they work
>great.
>> > They are shorter, but as you said, they do fit in the fuel rail 
>enough.
>> >
>> > Craig M.
>
>--------------------------------------------------------------------
>--------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>