[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: reprogramming '747 limp home mode
NickG wrote:
>
> How do you change the limp-home parameters in a '747? It sure isn't present
> in the 4K eprom that's usually modified.
Correct, the limp home parameters are set by resistors in the "other"
removeable chip.
--
Ludis Langens ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies: http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org