Re: Dumb ALDL Question No. 432

["Swayze" <kswayze@bellsouth.net>]

http://www.techedge.com.au/vehicle/aldl/160/aldl_sw.htm

this is direct to the page, you may want to back up on it a few directories
and read the whole thing.

byE
Mike
Swayze
mswayze@truswood.com
kswayze@bellsouth.net
<8-{b>
----- Original Message -----
From: "Scott Lundahl" <scott@lumenetics.com>
To: <gmecm@diy-efi.org>
Sent: Thursday, September 07, 2000 3:17 PM
Subject: Dumb ALDL Question No. 432


> Is there a quick and dirty DOS based program that will read the continuous
> 160 baud ALDL data stream from a '7747 (C3) ECU  and store to disk?  I
> don't need or want display during data collection; the data will be
> crunched later.  The idea is to freeze the BLMs at 128, capture MAP, TPS,
> RPM and integrator data and then run it through some well crafted excel
> spreadsheets to titrate the fuel maps (I'm sure this has already been
> done).  I could write one, but if it's already been done, why reinvent the
> wheel.
>
> Thanks,
>
> Scott
>
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org