[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: knock sensor installation
On smallblocks, the knock sensor is screwed into a hole just above the
oil pan on the side of the block. There's a hole on either side,
usually with a square headed plug in it.
--steve
"s. douglas taylor" wrote:
>
> i am ready to install my tbi conversion on my early sbc. my question is
> where/how is the best way the install the knock sensor? all my stuff came
> off an 89 s15 jimmy. on this truck screwed into a hole on the bellhousing
> flange. should i drill and tap a hole on my engine? i can do it, but hope
> there's an easier way.
> tia
> ciao...douglas
>
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
--
Steve Ravet
steve.ravet@arm.com
ARM,Inc.
www.arm.com
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org