Re: knock sensor installation

[Shannen Durphey <shannen@grolen.com>]

Many knock sensors are installed in the coolant drain hole in front of
the starter.  I think it's 1/4 NPT.  This is especially true of sbc
applications.
Shannen  

s. douglas taylor wrote:
> 
> i am ready to install my tbi conversion on my early sbc. my question is
> where/how is the best way the install the knock sensor? all my stuff came
> off an 89 s15 jimmy. on this truck screwed into a hole on the bellhousing
> flange. should i drill and tap a hole on my engine? i can do it, but hope
> there's an easier way.
> tia
> ciao...douglas
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org