Re: Am I going the wrong direction ?

[Len Sabatine <sabatine@epix.net>]

  This is Bass Ackwards. Think, like running too fat , Decrease VE in target
  Cells= enlean . Increase VE in target cells to enrich AFR.
  This statement assumes that Injectors are properly sized for Engine 
breathing
  requirement. Always make 1 change at a time, otherwise you'll not know which
  change helped or hurt .
  Len

> Hey guys. I'm trying to do a .bin to work with my setup so far. What I've
> done to start with is lower the values in the VE tables for the 90-100 Kpa
> range. By about 1-2%. That should richen up  the mixture right ? What I also
> did is advance the timing by about 3 degrees in the same 90-100 Kpa range.
> The car actually slowed down by 4 tenths.... :(   Am I going the wrong
> direction with the VE tables in TunerCat ? Should I increase those values ?
>
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org