Re: Australian 1227808 ECU data for .ecu file

[Ludis Langens <ludis@cruzers.com>]

Roger Merritt wrote:
> 
> I am in Australia using the 1227808 ECU on a toyota turbo engine.
> Another question I have is my
> calibration is currently using a 2bar sensor, how can I change this to 3bar?

What mask id is your '808 running?  The mask id is generally in the
ninth byte (location 0x8008 or 0xC008) of the EPROM.  Is your setup
stock OEM?  Or did some engine tuner mate the GM ECM with the Toyote
engine?  So far, I'm not aware of any stock 2bar (or 3bar) software for
the '808.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org