Re: Remote EPROM

["Christian Hack" <christianh@pdd.edmi.com.au>]

Sounds exactly like me, engine ran (only just and like crap)
after adding 8" of ribbon cable. Simply wrapping it in alfoil
fixed the problem. Didn't even have to ground it.

> Date: Mon, 12 Feb 2001 07:58:33 -0800
> From: romans@starstream.net (Romans, Mark)
> Subject: Re: Remote EPROM
>
> I have mine zif socket on the end of a 12" ribbon cable.  The ecm is
> in the stock location (87 Vet) and the ribbon cable runs over
> the outside
> of the ecm down to where the under dash light was.  This allows me to
> change the chip by leaning under the passenger side dash.
> This was extremely susceptible to RFI until I wrapped the ribbon cable
> in aluminum foil that is grounded to the case of the ecm.
> Mark


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org