Re: Need help

[ae2598@wayne.edu]

On Tue, 13 Feb 2001, Ludis Langens wrote:

> Here's what Ed Parks mentioned about this a long time ago:
> 
>   Fiero 2.8 ECM, 3.4 injectors, 3.4 engine:  ECM injects too much fuel
>   Fiero 2.8 ECM, 2.8 injectors, 3.4 engine:  Not enough fuel
> 
> You'll either need to play with the fuel pressure, or make/get a custom
> chip for the Fiero ECM.
> 
Does the 3.1 version of this motor use the same injectors as one of the
above listed motors?  If not, might it give you approximately the flow
rate you want?


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org