Ok from what I've seen I can use the syty code in the '730 if I load it in
the upper 16k of a 32k 27C256. Is that right? If so how do I get it into
the upper part of the EPROM. I'm using a pocket programmer if that helps
DanT
----- Original Message -----
From: "Jon Fedock" <heh@youwish.com>
To: <gmecm@diy-efi.org>
Sent: Sunday, February 18, 2001 5:39 PM
Subject: Re: Blown 350 with 1227730 ECM
> Just right off the top of my head, two of the biggies are the injector
> constant and egr bpw constants. Others aren't quite so glaring, but
> aggrivating if trying to accomplish something. Don't get me wrong, I am
> grateful for it, I used the addresses to tune with. Just gotta check
> everything. It does have alot of info, but there are gaps. If I just
wanted
> to use only what I NEED, I'd be using a carb and points
distributor.....;)
> ;) ;) <------------See the winkies
> Jon
>
> ----- Original Message -----
> From: Bruce Plecan <nacelp@bright.net>
> To: <gmecm@diy-efi.org>
> Sent: Wednesday, February 14, 2001 7:23 PM
> Subject: Re: Blown 350 with 1227730 ECM
>
>
> :
> : What is *alot of errors*?.
> : what do you NEED that promgrammer doesn't include?.
> : If we're talking about the same doc., then that is from GM.
> : Or you looking for a fully commented disassebmly, if so then I don't
know
> of
> : one.
> : Bruce
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org