Re: Maf to Map again

["Programmer" <nwester@eidnet.org>]

Guess that's why I'm wondering, since the 7730 was used in the "W" 2.8 and
in the 90 "F" body...may be a cheaper alternative to replacing a bad
MAF/relays, etc...and work as "well". If I can find further info, I'll post
it...kinda surprised nobody has done this ...

Lyndon.
-----Original Message-----
From: Ludis Langens <ludis@cruzers.com>
To: gmecm@diy-efi.org <gmecm@diy-efi.org>
Date: February 1, 2000 10:50 PM
Subject: Re: Maf to Map again


>nacelp wrote:
>>
>> Can any quote an application that was involved with this?.
>
>I think it was essentially all 1987-88 "W" 2.8 V6 engines.  1989 models
>are MAP only.  The SD upgrade chip for the older cars used the '89
>program (meaning that a chip editor for '89's will work for the SD
>upgrade chips too.)
>
>--
>Ludis Langens                               ludis (at) cruzers (dot) com
>Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org