Re: Debugger board for P4 ECMs

[Ludis Langens <ludis@cruzers.com>]

Swayze wrote:
> 
> > I can dump and alter memory, I/O, and registers including the PC.  I can
> > also run simple programs written in an interpreted language.  There's
>
> so can the same program be created with something like basic11 for a
> 68hc11 or could a VB like script be used.

The interpreted language that I implemented is a mix of the worst of
several other languages.  The best description is TinyBASIC with RPN
expressions.  It was designed for speed, not elegance.  You wouldn't
want to write a program longer than 20 lines.

This evening I needed to make the ECM hardware enter and leave limp-home
mode at about 1 Hz.  30 seconds and a 7 line program later, it was doing that.

> >serial interface to a laptop separate from the ALDL interface.  This
> >would require grafting debugger software onto GM's software.
> 
> this i'm assuming would be a patch to the control software in the MEMCAL.

Yes.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org