Re: MAF to speed density?

[Ken Kelly <kenkelly@lucent.com>]

Kelly,
	The Lt1-Editor software will allow you to do this.
http://carputing.com/
http://lt1.net/editor
		Ken

Kelly Parker wrote:
> 
> >I suggest just setting the 16188051 to speed density mode if you >really
> >need to go speed density.
> 
> I understand that it will need to be adjusted quite a bit. What I don't
> understand is exactly how I do that. There is not a (speed density/Maf)
> toggle switch on the engine :-)
> 
> thanks,
> Kelly
> 
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org