Re: Need help: power programming eprom

["nacelp" <nacelp@bright.net>]

Correct the check sum, or turn of it being run.
Most commercial softaware nowadays does that.
Grumpy


> I am having a problem getting my car's computer to "accept an eprom".
> If I put the exact same program into an eprom that was in my original chip
> it works fine, but as soon as I change any data, the car's computer chokes
> on it and goes into "limp home mode" when the service engine light stays
on
> and my diacom won't communicate. Is there some step I am missing?  Do you
> have to change some kind of check sum on the eprom for the computer to
> recognize a change or something?
>
>
> Jeff
> 93 Formula
> 77 Nova
> http://Go.To/LilDemon
>
> ________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org