IAT / MATs

["nacelp" <nacelp@bright.net>]

Anyone have a lead on a 3/8" pipr to 1/4" pipe thread reducer that is non
metallic?.
I want to isolate the sensor as much as possible from the heat soaking of
the engine.

BTW, the high end of the syty timing mat correction is 130.  So guess what?.
again ya run outta correction.
Brumpy

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org