[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: PCM's measuring torque.

To: <gmecm@diy-efi.org>
Subject: Re: PCM's measuring torque.
From: "Bruce Plecan" <nacelp@bright.net>
Date: Tue, 4 Jul 2000 09:33:23 -0400
References: <000f01bfe56d$4eb5da80$237d18cb@mainpc> <3961C5AD.A11B637F@clarityconnect.com>
Reply-to: gmecm@diy-efi.org
Sender: owner-gmecm@lists.diy-efi.org

> Ross Myers wrote:
> > How do PCM's measure (assume!) the Engine Torque values?. I have seen
this
> > as a ScanTool parameter, what is the software procedure for this?

I think Road and Track mentioned that some of the new PCM strategies use
monitoring shaft speeds pre and post torque converter, and knowing the
characteristics of the converter allow for a torque estimante.
Grumpy

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org

References:
- PCM's measuring torque.
  - From: "Ross Myers" <ponty@axis.jeack.com.au>
- Re: PCM's measuring torque.
  - From: Scot Sealander <Sealand@clarityconnect.com>

Prev by Date: RE: Crankshaft sensor
Next by Date: Re: Crankshaft sensor
Previous by thread: Re: PCM's measuring torque.
Next by thread: Re: PCM's measuring torque.
Index(es):
- Date
- Thread