RE: 2.8v6 tpi and a 730

[Mike Rolica <mrolica@meridian-mag.com>]

New tps as well
Mike Rolica
Plant A,
Magnesium Products Division
Strathroy

(519)-245-4040  Ext. 244



	-----Original Message-----
	From:	David Cooley [SMTP:n5xmt@triad.rr.com]
	Sent:	Tuesday, July 18, 2000 4:20 PM
	To:	gmecm@diy-efi.org
	Subject:	RE: 2.8v6 tpi and a 730

	At 03:47 PM 7/18/2000, you wrote:
	>Yep...every thing looks fine on diacom......cross counts could be
higher..
	>Even changed ecm, new o2 sensor, whent heated, ran new harness
ground and o2
	>wires....
	>
	>Hard to tell as it only happens when wot???or high speed..


	If you're still getting a code 13 but only at WOT, I'd check the
TPS...  If 
	it's not going over the WOT set point (85% or whatever is in the
chip) it 
	still thinks it's in part throttle mode, and the steady voltage with
no 
	cross counts you see at WOT is causing the code 13.


	===========================================================
	David Cooley N5XMT Internet: N5XMT@triad.rr.com
	Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
	I am Pentium of Borg... Division is Futile!
	===========================================================

	
----------------------------------------------------------------------------
	To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org