Re: Editing proms (editorial)

[Ludis Langens <ludis@cruzers.com>]

Kevin R wrote:
> 
> What you're saying is that it doesn't reevaluate the constant, but that the
> AFR settings for PE and WOT etc check the BLM settings and adjust
> accordingly !?? With in it's range of course.

Yes.

> I didn't realize that anything else used the BLMs for their calculations. Is
> this true for most/all fuel parameters?

The BLMs are used for "everything".  Under certain conditions, the ECM
does a sanity check of the BLM.  If the ECM doesn't like the BLM, it
"substitutes" a safer value.

Of course, the BLMs might not correct the VE table very well for PE
conditions.  That's when the actual AFR can vary from what the ECM
thinks it is injecting.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org