Re: Blown 350 with 1227730 ECM

[chetwagner@qwest.net]

If anyone is interested, I put together an ecu file for a conversion I 
completed last year.  I could have someone post it on incoming if I 
find it.  Some of the conversions are set for 1 bar map but can be 
adjusted without any problems.


On 19 Feb 2001, at 23:30, Dan Townsend wrote:

> It is going in a 87 Trans Am GTA.  I'm looking to have a blown 355 in
> the end with an aftermarket intake, vette or AFR heads, forged piston,
> blower friendly cam and probably a slightly better than stock crank. 
> Then all the little sutff that goes with all that.  Then I'm thinking
> of backing it with a T-56 from a 94-97 F-body and then a 12 bolt rear
> or 9 inch depending on what I find first.  I've got the suspension
> basically done and now I wanna go fast :-)  I verified this weekend
> that I can still drive a stick so it should all be done this year if I
> just get one of the jobs that I'm interviewing for.
> 
> BTW - Could you send me the turbo p4 document you speak of?  I'll have
> the ecu on the site when I finish it.  Shouldn't take too long since I
> spend 8-12 hours a day on car stuff.
> 
> DanT
> 

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org