Re: Blown 350 with 1227730 ECM

["Dan Townsend" <xybertron@cox-internet.com>]

Please send it to me.  I'll post it on my webpage that I'm trying to create
with what I've learned and maybe one day it will look decent :-)  I started
my ecu today and got 12 values done.  Mostly maps and the important to me
stuff.

DanT

----- Original Message -----
From: <chetwagner@qwest.net>
To: <gmecm@diy-efi.org>
Sent: Tuesday, February 20, 2001 11:36 PM
Subject: Re: Blown 350 with 1227730 ECM


> If anyone is interested, I put together an ecu file for a conversion I
> completed last year.  I could have someone post it on incoming if I
> find it.  Some of the conversions are set for 1 bar map but can be
> adjusted without any problems.
>
>
> On 19 Feb 2001, at 23:30, Dan Townsend wrote:
>
> > It is going in a 87 Trans Am GTA.  I'm looking to have a blown 355 in
> > the end with an aftermarket intake, vette or AFR heads, forged piston,
> > blower friendly cam and probably a slightly better than stock crank.
> > Then all the little sutff that goes with all that.  Then I'm thinking
> > of backing it with a T-56 from a 94-97 F-body and then a 12 bolt rear
> > or 9 inch depending on what I find first.  I've got the suspension
> > basically done and now I wanna go fast :-)  I verified this weekend
> > that I can still drive a stick so it should all be done this year if I
> > just get one of the jobs that I'm interviewing for.
> >
> > BTW - Could you send me the turbo p4 document you speak of?  I'll have
> > the ecu on the site when I finish it.  Shouldn't take too long since I
> > spend 8-12 hours a day on car stuff.
> >
> > DanT

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org