Felpro 1010s

["Bruce Plecan" <nacelp@bright.net>]

I did wind up using these again, AND there was a design change, in how the
water passages are done.   So maybe was a matter of the water circulation,
was the major contibutor to them blowing.
Again this is about the Felpro SBC AL head headgaskets.

Time will be the ultimate answer, but, for now I'll stick to my Tuning 101,
as still being correct.  Since even is slightly wrong took over 50K for them
to fail, and was a minor failure at that.
Bruce

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org