Re: Mechanical end of K/S tests

["Jeffery Green" <jgreen11@cfl.rr.com>]

Is this the engine you were going to polish and Thermal Coat. If so what all
did you have coated.




----- Original Message -----
From: "Bruce Plecan" <nacelp@bright.net>
To: <gmecm@diy-efi.org>; <diy_efi@diy-efi.org>
Sent: Saturday, February 24, 2001 2:56 PM
Subject: Mechanical end of K/S tests


>
> Finished the SBC with the AL heads that I had smoothed the chambers, and
> exhuast ports.     Other then not being able to warm up, or pass the ESC
> test things are wonderful.
> Probably will have to go to a recirculating thermostat to get things hot
> enough for the heater to be meaningful.
> Also, codes for the ESC, with even an additional 4d timing.
> Kinda a game call, but the engine seems perkier, to drive
> Seems like a well spent $15, in my book.
> Bruce
>     Going for WI, on N/A engines now.   While min, I can't help to think
any
> carbon build up is a bad carbon build up.
>
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org